Napco Security Technologies GEM-DXK3 Bedienungsanleitung PDF herunterladen (Seite 11)

FIRE PROTECTION

(Applicable only where local ordinance permits use of this alarm control panel for fire protection).

Fire-Zone Alarm

If a fire is detected, the FIRE/TBL light will display with the zone number and the

keypad sounder will pulse.

• If a fire is in progress, evacuate the premises immediately! If necessary, call

the Fire Department from an outside phone.

• If there is no evidence of a fire, enter your code and press

U to silence the

alarm.

• Check the smoke detector(s). If a smoke detector tripped, its red alarm

indicator light will be on.

• After the alarm condition is corrected (thermostat cooled down; smoke cleared

from detector; etc.), pressing

C again will reset the keypad within about

10 seconds.

Fire-Zone Trouble

• The system is constantly monitoring the Fire Zone(s) to insure they are in good

working order.

• If a problem on a Fire Zone is detected, a system trouble E41 will display,

followed by the number of the Fire Zone in trouble. The sounder will activate, the

SYS TBL light will come on and the FIRE/TBL light will blink.

• Press the

C button to silence the sounder. Call for service immediately!

INTERIOR

BYPASS FIRE/TBL SYS TBL CHIME

INTERIOR

BYPASS FIRE/TBL SYS TBL CHIME

INTERIOR

BYPASS FIRE/TBL SYS TBL CHIME

INTERIOR

BYPASS FIRE/TBL SYS TBL CHIME

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Keine Kommentare

Napco Security Technologies GEM-DXK3 Bedienungsanleitung Seite 11