Napco-security-technologies F-TPG Bedienungsanleitung

1 © NAPCO 2005 PATENTED OI309 10/05 RUsing your NAPCO FREEDOM F-TPG Garage Touchpad Home Security System F-TPG_OI309.06_U

10 EXITING WITH THE SYSTEM ALREADY ARMED 1 Press the STAY button on the Touchpad. The ARMED indicator will light and STAY will begin to flash, i

11 EXITING WITH THE SYSTEM ALREADY ARMED 1 Press the AWAY button on the Touchpad. The ARMED indicator will begin to flash, indicating that you h

12 EMERGENCY BUTTONS The Emergency Buttons, if programmed, are always active, whether the system is armed or disarmed. The Emergency Button must be

13 DISARMING THE SYSTEM DISARMING WHEN RETURNING HOME: When returning home, opening your garage door (by pressing A1 or A2 on your Keyfob) from the

14 If an alarm occurs while you are at home: The Garage Touchpad siren will sound and the red ARMED light will flash. Proceed with caution! If you s

15 If a fire is detected, the siren will sound a distinct pulsating tone and the FIRE indicator on the Ga-rage Touchpad will be flashing. If a Fire

16 FIRE PROTECTION Preparing a Fire Escape Plan Even with the most advanced fire alarm system, adequate protection requires an escape plan. To prepare

17 Your Freedom Alarm System is constantly monitoring its own components, as well as all critical services, such as AC power and the telephone line, t

18 SYSTEM TROUBLE ERROR CODES TBL Flashes / Touchpad beeps READY Flashes Trouble Condition Action 6 NONE Lost Key Mode This is a rem

19 The space below is for recording the descriptions of the zones in your system. • If the system has a faulted zone, count the number of READY ligh

2 Congratulations on your purchase of a new Freedom Garage Door Security Sys-tem. This revolutionary new concept in residential security makes using

20 The F-IFOB is a uniquely coded digital key which performs the following functions when inserted into the F-IFOB slot on the Ga-rage Touchpad: •

21 Lost Opener Mode In the event that your garage door remote control (or key that operates your garage door opener) is lost or stolen, the system

22 FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 68 STATEMENT This equipment complies with Part 68 of the FCC rules. On the front cover of this equipm

23 WARNING! THE LIMITATIONS OF THIS ALARM SYSTEM While this system is an advanced design security system, it does not offer guaranteed protection aga

24 WARNING! THE LIMITATIONS OF THIS ALARM SYSTEM (Continued) • Even if the system responds to the emergency as intended, however, occupants may have

25 NAPCO LIMITED WARRANTY NAPCO SECURITY SYSTEMS, INC. (NAPCO) warrants its products to be free from manufacturing defects in materials and workmansh

26 written, are either merged herein or are expressly cancelled. NAPCO neither assumes, nor authorizes any other person purporting to act on its behal

27 THE FOLLOWING STATEMENT IS REQUIRED BY THE FCC RADIO AND TELEVISION INTERFERENCE This equipment has been tested and found to comply with the limi

28 333 Bayview Avenue Amityville, New York 11701 For Sales and Repairs, (800) 645-9445 For Technical Service, (800) 645-9440 Publicly traded on NA

3 TABLE OF CONTENTS TABLE OF CONTENTS INTRODUCTION ...2 TESTING THE SYSTEM

4 READY ARMED STAY FIRE TBL • GARAGE TOUCHPAD INDICATORS The green READY light shows the status of the zones in your system: ON indicates that all zon

5 GARAGE TOUCHPAD CONTROLS STAY Button - Press to arm system in the STAY mode. Perimeter devices such as windows and doors will be protected, while

6 ARMING WHEN LEAVING 1 Check the Garage Touchpad indicators. The green READY light should be ON-STEADY, indicating that the system is ready to arm.

7 BYPASSING FAULTED ZONES If you are trying to arm with a faulted zone or zones, the green READY light will be blinking out the number of the faulted

8 ARMING WHEN STAYING HOME Arming in the Stay mode allows you to remain home with the perimeter protection active and the interior protection off, so

9 ARMING AND LEAVING WITH OTHERS STAYING 1 Check the Garage Touchpad indicators. The green READY light should be ON-STEADY, indicating that the syst